• 23701
    1

Product Information

  • High wear protection
  • Accuracy of fit
  • Strict quality standards
  • Compliance with the requirements of vehicle manufacturers

Vehicle Repairs. We've Got What it Takes.

The greatest challenge for modern, technologically complex vehicles is the balance between performance, economy, and environmental compatibility. However, many of the roads they drive on are far from perfect. As a result, the chassis and the steering are often subjected to extreme loads, which accordingly increases the quality demands placed on wear parts.

Steering parts in particular are subject to special care in design, manufacturing, and assembly. This is why febi only offers steering parts in OE matching quality. In order to maintain stable road holding, even in hazardous situations, all installed steering parts must meet the high requirements of precise and high-quality production.

With a large selection of safety-relevant steering components, febi makes a contribution to road safety.

Quality by Conviction

In order to ensure absolutely reliable absorption of the vertical and horizontal forces that occur during acceleration, braking, and cornering, febi's control arm mounting kits are intensively tested.

Our quality management tests the products offered for various requirements and loads. These include fitting accuracy, dimensional accuracy, material quality, tensile strength, and degrees of hardness.

In the area of steering technology, febi is one of the leading suppliers in the Independent Aftermarket. The product range exclusively includes control arm mounting kits that guarantee 100% driving stability and meet, or even exceed, the approval requirements.

Supplied Complete. Repaired Non-stop.

In everyday workshop life, it is not uncommon for a worn part to have to be replaced as well as any fixings. However, these additional parts - usually bolts or nuts - are often not included with the individually available replacement part.

With the ProKits, febi provides a remedy by offering control arm mounting kits with all attachments required for fair value repair. In addition to control arm bearings, attachment brackets, and ball joints, these kits can also include nuts, bolts, washers, and spring washers.

Kit Content
description Number Characteristics
21439 Control Arm with bush, joint and nut 1
  • article version: old implementation
  • Fitting Side: front
  • Fitting Side: front axle left
  • Fitting Side: lower
  • Material: aluminium
  • outer length: 418 mm
21440 Control Arm with bush, joint and nut 1
  • article version: old implementation
  • Fitting Side: front
  • Fitting Side: front axle right
  • Fitting Side: lower
  • Material: aluminium
21441 Control Arm with bush, joint and nut 1
  • Fitting Side: front axle left
  • Fitting Side: lower
  • Fitting Side: rear
  • Material: Cast Steel
21442 Control Arm with bush, joint and nut 1
  • Fitting Side: front axle right
  • Fitting Side: lower
  • Fitting Side: rear
  • Material: Cast Steel
21560 Eccentric Bolt with levelling discs and nuts 4
  • Fitting Side: front axle both sides
  • Length: 122 mm
  • Outside Thread: M14 x 1,5
19333 Stabilizer Link with lock nuts 2
  • Fitting Side: front axle both sides
  • Length: 276 mm
  • Outside Thread: M10 x 1,5
OE-Comparison
Suitable for Manufacturer OE-Number
Mercedes-Benz 203 330 39 11 S2
Used In Vehicles