40501


40501

Tie Rod with steering boot set

Fitting Position: front axle left
3 years warranty febi
Characteristics
Additional Information / Parts
Additional Information / Parts:
with clamps
Material
Material:
steel
Outside Thread
Outside Thread:
M14 x 1,5

Product Information

  • Long service life
  • Optimal fitting accuracy for easier repairs
  • Strict quality standards
  • Compliance with the requirements of vehicle manufacturers

Vehicle Repairs. We've Got What It Takes.

The greatest challenge for modern, technologically complex vehicles is the balance between performance, economy, and environmental compatibility. However, many of the roads they drive on are far from perfect. As a result, the chassis and the steering are often subjected to extreme loads, which accordingly increases the quality demands placed on wear parts.

Steering parts in particular are subject to special care in design, manufacturing, and assembly. This is why febi only offers steering parts in OE matching quality. In order to maintain stable road holding, even in hazardous situations, all installed steering parts must meet the high requirements of precise and high-quality production.

In order to maintain stable road holding, even in hazardous situations, all installed steering parts must meet the high requirements of precise and high-quality production. With a large selection of safety-relevant steering components, including tie rods, febi makes a contribution to road safety.

Quality by Conviction

Tie rods from febi are intensively tested. Our quality management tests the offered products for different requirements and loads. These include fitting accuracy, dimensional accuracy, material quality, tensile strength, and degrees of hardness.

In the area of steering technology, febi is one of the leading suppliers in the Independent Aftermarket. The range exclusively includes tie rods that guarantee 100% driving stability and meet, or even exceed, the approval requirements of vehicle manufacturers.

Supplied Complete. Repaired Non-stop.

In everyday workshop life, it is not uncommon for a worn part to have to be replaced as well as any fixings. However, these additional parts - usually bolts or nuts - are often not included with the individually available replacement part.

With the ProKits, febi provides a remedy and offers tie rods with all the attachments required for repair at fair value (e.g. tie rod end piece and lock nut).

Kit or Set Content
description Number Characteristics
21565
Axial Joint with counter nut and locking washer 1
  • Fitting Position: front axle left
  • Fitting Position: front axle right
  • Length: 340 mm
  • Outside Thread: M14 x 1,5
  • Outside Thread: M16 x 1,5
21563
Tie Rod End with lock nut and nut 1
  • Fitting Position: front axle left
  • internal thread: M14 x 1,5
  • Length: 90 mm
  • Material: steel
22535
This article is not sold separately.
Steering Boot 1
  • Fitting Position: front axle left
  • Fitting Position: front axle right
  • inner diameter 1: 11 mm
  • inner diameter 2: 41 mm
  • Length: 200 mm
  • Material: rubber
38756
Clamping Clip 1
  • clamping range from: 19,4 mm
  • clamping range to: 22,6 mm
  • Fitting Position: front axle left
  • Fitting Position: front axle right
  • Fitting Position: outer
  • Material: stainless steel
  • Width: 7 mm
38762
Clamping Clip 1
  • clamping range from: 47,5 mm
  • clamping range to: 56 mm
  • Fitting Position: front axle left
  • Fitting Position: front axle right
  • Fitting Position: inner
  • Material: stainless steel
  • Width: 7 mm
Customers also changed
Technical information

Selected Language / Multilanguage

    Alternate Language

    Comparison Number(s)
    Suitable to replace Reference(s)
    Volvo 274224 S1
    Used In Vehicles