• 43792
    1

Product Information

  • Longevity
  • Accuracy of fit
  • Strict quality standards
  • Compliance with the requirements of vehicle manufacturers

Vehicle Repairs. We've Got What it Takes.

The greatest challenge for modern, technologically complex vehicles is the balance between performance, economy, and environmental compatibility. However, many of the roads they drive on are far from perfect. As a result, the chassis and the steering are often subjected to extreme loads, which accordingly increases the quality demands placed on wear parts.

Steering parts in particular are subject to special care in design, manufacturing, and assembly. This is why febi only offers steering parts in OE matching quality. In order to maintain stable road holding, even in hazardous situations, all installed steering parts must meet the high requirements of precise and high-quality production.

With a large selection of safety-relevant steering components, including inner tie rods, febi makes a contribution to road safety.

Quality by Conviction

Inner tie rods from febi are intensively tested. Our quality management tests the products offered for various requirements and loads. These include fitting accuracy, dimensional accuracy, material quality, tensile strength, and degrees of hardness.

In the area of steering technology, febi is one of the leading suppliers in the Independent Aftermarket. The range exclusively includes inner tie rods that guarantee 100% driving stability and meet, or even exceed, the approval requirements

Supplied Complete. Repaired Non-stop.

In everyday workshop life, it is not uncommon for a worn part to have to be replaced as well as any fixings. However, these additional parts - usually bolts or nuts - are often not included with the individually available replacement part.

With the ProKits, febi remedies this situation and offers inner tie rods with all the attachment parts required for repair at the right time. febi ProKit is the tailor-made, complete solution in which necessary repairs can be carried out without delay.

Videos
Kit Content
description Number Characteristics
43791
This article is not sold separately.
Axial Joint with nut 1
  • Length: 314 mm
  • Length: 330 mm
  • Outside Thread: M16 x 1,5
  • Thread Length: 65 mm
  • Wrench Size (metric): 38 mm
38755 Clamping Clip 1
  • clamping range from: 16,0 mm
  • clamping range to: 19,2 mm
  • Material: stainless steel
  • Width: 7 mm
38763 Clamping Clip 1
  • clamping range from: 53,5 mm
  • clamping range to: 62 mm
  • Fitting Side: vehicle-dependent installation sides
  • Material: stainless steel
  • Width: 7 mm
OE-Comparison
Suitable for Manufacturer OE-Number
Buick 13332653
Chevrolet 13332653
Opel 16 09 183
Vauxhall 13332653
Used In Vehicles